cdppfaq.html

FAQ for H45 Quick CD Parallel Port:

Q: Does the TSR drivers work in Windows 95/98 ?
A: No, the TSR drivers will not work in Windows 95/98

Q: What is the Quickest way to check if the QuickCD is working or not.
A: Download our bootable disk from our website and make it bootable by
following the instructions that comes with it. Then bootup with the disk
that you created and you should be able to access the Quick CD in DOS.

Q: What Parallel Port Mode will work with the Quick CD?
A: EPP (Enhance Parallel Port), Bi-directional, PS/2, Extended, Enhance,
and some Standard Modes may work.

Q: After upgrading to Windows 95/98 from DOS/Win 3.x, my Quick CD
      does not work any more. What can I do ?
A: Edit your Config.sys file and REM out the following lines
           Device=c:\h45cd\h45cd.sys
           Device=c:\h45cd\aspicd /d:aspi_cd
     Edit your Auotexec.bat file and REM out the following line:
           mscdex.exe /d:aspi_cd
A: Install the Drivers for Windows 95/98.

Q: How do I get to the BIOS?
A: On Most Laptops, Pressing the F1, F2, or F10 keys will allow you
      to go into the BIOS Setup while the computer is booting. This
      can only be done BEFORE your computer starts to load Windows
      or DOS.
A: On Most Desktops computers, Pressing the Del key will allow you
      to go into the BIOS Setup while the computer is booting. This
      can only be done BEFORE your computer starts to load Windows
      or DOS.
A: The BIOS can also be refer as the CMOS, or System SETUP. If
      the above instructions do not work, refer to your Computer's
      manual or contact the manufacture of your computer for assistant.

Q: My computer freeze when I install the drivers in Windows 95/98.
      What can I do ?
A: Install the Drivers without connecting the QuickCd to your computer.
      At the end of the installation, select " I will connect the Device Later"
      and click on NEXT and then Finish.

Q: My Quick CD work in DOS but does not work in Windows 95/98.
A: Check if there are any Resource Conflicts.

Q: When I click on the CD ROM Icon in My Computer, It tell me
      that the CD Drive is not Accessible and the Device is not ready.
A: Make sure there is a CD in the drive.
A: Make sure that the CD is ON. If not, you need to restart your
     computer with the QuickCd turned on
A: On the Slim Quick CD, Make sure that the CD snap onto the
      center Spindle and not laying loosely on the CD Tray.